WiFi External Antenna for V2 AutoGen
$ 20
- Description
- Additional information
Description
Additional information
Weight | 0.1 kg |
---|---|
Dimensions | 50 × 45 × 40 cm |
I purchased the V6 AutoGen controller for my manual Predator 9500 inverter generator so that it could start the generator automatically in case of a power outage and power my house. After many weeks of trial and error and LOTS OF HELP from customer service, the controller is finally working properly. Be careful while wiring the controller, I made a mistake and wired the controller directly to the generator without using relays and accidentally burned out the starter pin #4 (the controller can only handle 1A of max current), but the controller still managed to work after using customer support’s suggestion of repurposing pin #5 as a starter pin. So far im happy with the controller and I recommend it.
WOW !!! The Best After Sales Service In My Life.
I bought a 24 volt V2 auto gen control to run my generator especially for late fall and winter to run my 120 volt refrigerator and radiant floor system.
The generator serves as a back up to my solar panels to recharge my battery bank
I installed it on a Honda generator 3000is and everything works fine.
I want to thank Nick for his extraordinary kindness and patience.
Believe me you will not be disappointed.
Thank you for your review Daniel.
It was a pleasure!
I purchased the AutoGen V2 as a solution to make a portable generator to become a standby generator for a small FM radio transmitter shack. Nick Alexander was there the whole time -- before and after the sale. His support and immediate help (when possible) will win your confidence to see your project end successfully.
Have two Autogen v2 systems setup to keep a constant power source on a remote location.
Main generator turns off and on via the Autogen v2 on a set timer. When it turns off, the propane generator kicks in for the remainder of the day.
Excellent system, excellent support. Nick wrote some custom code specifically for this operation.
Thanks again!
Glad to help out with the installation Cee.
I must admit, it was a fun project!
As full-time off-gridders since 2008, our remote location makes it difficult to maintain our batteries if we are absent during weeks of prolonged low solar output (typically November through January). With temperatures regularly dipping below -20 degrees C during this period, having our older 4cyl diesel Onan generator controlled remotely via my phone has given us the freedom to leave our home for extended periods of time without worrying about broken water pipes. Nick and Elena were awesome during the entire process, answering my incessant questions promptly and patiently. Once we were ready to hook-up our V7, both and Nick and Elena were there again, giving us fantastic customer service.
OUR SYSTEM: The V7 is mounted in a weatherproof box, which is placed within the generator shelter. The unit operates in the outside ambient temperature, and the unit has operated successfully down to -30 degrees C (I made sure to test it when the temperature dropped). The unit is powered by 12vdc and instead of using the generator starting battery to power the unit, I used 48vdc POE over a 40 m CAT6 patch cable, then used a POE-compatible dc-dc converter to reduce the voltage to 12vdc. The data connection is achieved via CAT6 cable and POE is injected into the twisted pair directly from the 48vdc breaker panel (off the battery bank). To ensure a good start each time, I keep an extension cord from the house hooked-up to the generator’s block heater and a 2amp battery charger hooked-up to the generator starting battery. The power to the extension cord is controlled by a smart switch, which allows me to remotely control the length of time the charger and block heater are operating. We used a Roadmaster 790 Hy-Power Diode to connect the V7’s starter cut-off switch (prevents racing the starter during start-up) but noted there was some voltage drop across the diode, so the alternator charges the starting battery at 13.8vdc, not 14.6vdc (which is why we use the 2amp charger, jic).
Once I had the unit wired-up, Nick remotely adjusted the programming on the unit to accommodate my start-up needs (timing for the glow-plugs, long shut-down sequence to ensure the fuel solenoid turned off, etc.). Aside from a few issues due to my poor familiarity with the App (since rectified), the unit worked perfectly. I have never heard the starter race during all the times I have used the V7 to start the generator, even remotely (I listen to the generator start-up via my Mobotix doorbell and camera).
Having the V7 attached to our generator has given my family the year-round freedom of travel we have been seeking since we moved out here in 2008. Our solar system handles our power requirements for most of the year, and we only rely on the generator for approximately 90 hours of use per year. But that sweet 8kW array (on Deger tracking system) doesn’t help you when the sun isn’t shining, your power system is failing, and you’re not home.
Thank you, Nick and Elena. Your patience, professionalism, and high-quality product means a lot, and I have no problem recommending your products to anyone, even those living in the frigid corners of North America.
You may also like…
-
AutoGen Generator Controllers
V2 AutoGen 48v auto start generator controller
38 reviewsSelect options This product has multiple variants. The options may be chosen on the product pageQuick View -
AutoGen Generator Controllers
V2 AutoGen 24v auto start generator controller
38 reviewsSelect options This product has multiple variants. The options may be chosen on the product pageQuick View -
AutoGen Generator Controllers
V2 AutoGen 12v auto start generator controller
38 reviewsSelect options This product has multiple variants. The options may be chosen on the product pageQuick View -